Suggestion: Disable Layouttoolbox if only one ...

Peter · Post by **Peter** » 08 Nov 2007, 15:42

I think it would be an improvement if the Layouttollbox becomes more "intelligent":

If
- in a drawing is only modelspace (i.e. DXF, older DWG) or
- in a plot is only one page the layouttollbox should be disabled.

This is usefull because now if have always to click on the box to see if there are more entries. If it is disabled I can see immediatly that there are no other layouts or pages.

Peter

Post by **support** » 08 Nov 2007, 16:37

Hello Peter,

Thank you for the interesting thought. We will consider it.

Sergey.

Please post questions to the forum or write to support@cadsofttools.com

Peter · Post by **Peter** » 11 Nov 2007, 12:57

Or - instead of disabling the toolbar - you can add additional info in the bar:

- "2 Page(s) found in Plotfile"
- "1 Modell and 3 Layout(s) found in DWG"

Peter

Post by **support** » 12 Nov 2007, 16:15

OK. Thanks again, Peter. We will consider this question.

Sergey.

Please post questions to the forum or write to support@cadsofttools.com

Peter · Post by **Peter** » 24 Apr 2009, 16:11

Seem to be added, but not listed in "History.txt / Changes.txt".

True?

Peter

Post by **support** » 24 Apr 2009, 16:38

True!

CADSoftTools