Adding jpg to DXF, but not in CAD to G-Code

inLOOPer · Post by **inLOOPer** » 27 Jul 2022, 22:31

I have a project I've started where I start with a rectangle.
In the Editor tab, I add a line drawing jpg image of our logo.
It shows fine in the editor screen, but when i go to the Output tab and choose CAD to G-Code, the logo is not there.
Any suggestions?

Post by **support** » 29 Jul 2022, 17:18

Hi,

The software ABViewer enables a generation to G-code only lines, lopylines, i.e. - a file which contains a vector image.

Kind regards,
Suraya

CADSoftTools

Adding jpg to DXF, but not in CAD to G-Code

Adding jpg to DXF, but not in CAD to G-Code

Re: Adding jpg to DXF, but not in CAD to G-Code

Connect with your social network account

Adding jpg to DXF, but not in CAD to G-Code

Adding jpg to DXF, but not in CAD to G-Code

Re: Adding jpg to DXF, but not in CAD to G-Code